CHOICE Sign Building Instructions
Step by step instructions for constructing a handheld “CHOICE” sign
CBR is dedicated to exposing the sin of abortion so that our nation will become convicted to stop the killing. We are very thankful for your help in being a witness for truth in your community. Below are instructions on how to construct a handheld “CHOICE” sign so that you may effectively reveal the harsh reality of “choice.” Thanks again for being a bold testimony against the killing of unborn children.
Step 1.
Find a local sign company in your community (i.e. Sign-O-Rama) and purchase a sheet of corrugated plastic board. 1/4 inch thick is good, but 1/2 inch thick is better. A sheet of corrugated plastic board is usually 4’ X 8’ and can cost between $10-20 per sheet. The sign company may cut you a 3’ X 4’ sheet at an additional charge.
Step 2.
Before applying the self-adhesive vinyl sign to the corrugated plastic board, you must clean the corrugated plastic board and remove any dirt.
Step 3.
Once the corrugated plastic board is clean, find an old Windex or window cleaner bottle that is half full. Add water to the Windex or window cleaner bottle and make sure the bottle contains 50% water and 50% Windex/window cleaner. You can also add one drop of dish soap to a bottle of just water.
Step 4.
After water is added, spray the Windex/window cleaner evenly on the corrugated plastic board. Make sure that the entire surface is wet.
Step 5.
Peel handheld “CHOICE” sign from back paper. Apply the sign to the corrugated plastic board. Center the sign.
Step 6.
After the sign is centered and applied to the corrugated plastic board, make a squeegee from a scrap piece of cardboard. Bend the piece of cardboard to make the squeegee. Use the squeege to flatten the sign wrinkles and push out the Windex/window cleaner that is under the sign. Make sure that the entire Windex/window cleaner is removed from the corrugated plastic board before allowing the sign to dry.
Step 7.
Once the entire Windex/window cleaner is removed from the corrugated plastic board, let the sign dry overnight or for 24hrs. Place books or heavy objects on the sign, especially at the edges, to ensure that the sign sticks to the corrugated plastic board.
Step 8.
After the sign is dry, go to your local high school, abortion mill, or college campus to educate your community about what abortion does to unborn babies.
If you come across any difficulties with making a Handheld “CHOICE” sign, please contact CBR Midwest to assist you: 614-759-5195